HURAKAN HKN-SV12 Mode D'emploi page 15

SETUP (temperature / time)
1. Plug the appliance into a power outlet. In this case, the «
» icon appears on the display, the operation indicator
lights up, and the device switches to the standby mode.
Click on the « » icon to enter the settings mode. Each
pressing will be accompanied by a sound signal.
Press and hold the « » icon for 3 seconds to switch to
if available.
The default value is
2. Temperature setting. To set the temperature, press the
(+) or (-) buttons.
3. Time setting. To set the time, click on the «
First press the (+) or (-) button to set the hours, then press «
minutes.
The timer starts counting down the time during which the preset temperature is
reached.
4. Click on the « » icon to confirm the setting, after which the device will start working.
To change the settings, press and hold the «
the setting as described above.
At the end of the countdown, the device automatically stops and the "END" icon is
displayed on the screen.
5. To stop the device, press and hold the « » icon for 3 seconds.
Maintenance
• Always turn off the device and disconnect it from the power supply.
• Maintenance of the internal components of the device must only be
carried out by qualified personnel.
• Before work, let the device cool down to room temperature.
Check the device for damage, including the cord, to the system or
heaters. If signs of damage are found, return the device to the
manufacturer to replace parts.
Cup installation
While holding and pressing the clamp, align the unlock symbol with the arrow
and rotate the cup clockwise until the arrow and the lock symbol are aligned.
Take care when inserting a stainless steel impeller into the hole in the stainless
steel cup so than not to damage the impeller.
Cup removal
While holding and pressing the clamp, turn the cup counterclockwise to remove
it. Take care to avoid damage to the stainless steel impeller from contact with
the stainless steel cup.
All manuals and user guides at all-guides.com
o
C. The setting is stored in memory.
o
F,
» icon. The timer indication will flash.
»icon for 3 seconds, and then repeat
EN
» again to set the
15