Zyxel PL-100 Mode D'emploi page 3

Connecting the PL-100 to a Cable/DSL Modem and Ethernet Switch
1 Connect an Ethernet cable to the port on the PL-100.
2 Connect the other end of this Ethernet cable to an available Ethernet LAN
port of your router or switch (or modem-router device).
3 Plug the PL-100 into a wall socket.
4 Confirm that the PWR, LINK and ETHN LEDs on the PL-100 are on.
5 Install software (PL-100 Configuration Utility) from the ZyXEL resource CD
(see User's Guide for detailed software installation and setup).
ENGLISH
2