AirKing AK55L Manuel D'opération page 4

4. Install light reflector into grill by lining up the posts on grill with
the holes in light reflector (Figure 11). Raise light reflector and
grill up to housing and insert plug from light into receptacle
marked "LIGHT" (Figure 9).
Figure 11
5. Attach light reflector in place with the two nuts removed during
Step 2 in SECTION 1 Preparing the Unit so grill fits snuggly
against ceiling (Figure 12).
Figure 12
CAUTION:
FAILURE TO SECURE THE REFLECTOR SCREWS
MAY RESULT IN A RATTLING OR HUMMING NOISE.
6. Install the appropriate bulb (not included) specific to your
model:
AK55L: Install a 100 watt maximum, type A19 medium base
incandescent bulb (not included).
WARNING:
TO REDUCE THE RISK OF FIRE, USE ONLY TYPE
PL OR CF, 4-PIN CFQ26W/GX24Q LAMP, 26 WATT MAXIMUM.
AKF55: Install an Air King model 26WFL or a compatible
CFM26W/GX24Q lamp. (not included).
7. Close the light lens and secure in place by swinging back
into position and snapping the tabs in place (Figure 13).
Connector Bar
Figure 13
210575055 Rev. A 8-06
Post
Hole
Post
Nuts
Tabs
www.airkinglimited.com
8. Restore power and test your installation.
SECTION 7
Use and Care
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
1. Cleaning the Grill: Reverse the instructions in Section 6
Completing the Installation to remove grill. Use a mild
detergent, such as dishwashing liquid, and dry with a soft
cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING
POWDERS. Completely dry grill before reinstalling. Refer to
instructions in Section 6 Completing the Installation , to
reinstall grill.
2. Cleaning the Fan Assembly: Wipe all parts with a dry cloth
or gently vacuum the fan. NEVER IMMERSE ELECTRICAL
PARTS IN WATER.
CAUTION:
ALLOW BULB TO COOL BEFORE REPLACING.
3. Changing the Light Bulb: Disconnect power to the unit. Open
light lens by pushing in on the two tabs of light lens and pulling
outward from lens. The lens will swing open on the connector
bars. DO NOT remove the lens from the grill (Figure 14).
Incandescent Bulb (AK55L): Unscrew bulb from lamp
holder and replace with a 100 watt maximum, type A19
medium base incandescent bulb.
WARNING:
TO REDUCE THE RISK OF FIRE, USE ONLY TYPE
PL OR CF, 4-PIN CFM26W/GX24Q LAMP, 26 WATT MAXIMUM.
Fluorescent Bulb: Remove lamp by gently rocking lamp
back and forth while applying outward pressure to release
the lamp from the base. Replace with Air King model
26WFL or a compatible CFM26W/GX24Q lamp.
Sylvania model: CF26DD/E/835
GE model: F26DBXT4SPX35/4P
Phillips model: PL-C 26W/835/4P/ALTO
Connector Bar
Figure 14
Tabs
4 of 12