Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

IMPORTANT INSTRUCTIONS -
Models: AK200LS, AK280LS,
AK300LS
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
electric shock and injury to person, including the following:
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
AND INJURY TO PERSON, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer.If
you have questions, contact the manufacturer.
b) Before servicing or cleaning the unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
AND INJURY TO PERSON, OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-related construction.
b) Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA) and the
American Society for Heating, Refrigeration, and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
c) When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
A210572051 Rev. D 10-13
OPERATING MANUAL
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
SAVE THESE INSTRUCTIONS
d) Ducted fans must always be vented to the outdoors.
e) If this unit is to be installed over a tub or shower, it must be marked
as appropriate for the application and be connected to a GFCI
(Ground Fault Circuit Interrupter) - protected branch circuit.
f) This unit must be grounded.
g) To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power unit.
CAUTION:
USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS AND
VAPORS.
WARNING:
h) Read all instructions before installing or using exhaust fan.
www.airkinglimited.com
Exhaust Fan
FOR GENERAL VENTILATING USE ONLY. DO NOT
DO NOT USE IN KITCHENS.
1 of 8

Publicité

loading

Sommaire des Matières pour AirKing AK300LS

  • Page 1 IMPORTANT INSTRUCTIONS - OPERATING MANUAL Models: AK200LS, AK280LS, Exhaust Fan AK300LS READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2 INSTALLATION INSTRUCTIONS Ducting CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE STARTING INSTALLATION. Duct SECTION 1 Collar Preparing the Exhaust Fan Unpack fan from the carton and confirm that all pieces are present. In addition to the exhaust fan you should have: 1 - Grill 1 - Damper Assembly (attached)
  • Page 3 Run wiring from an approved wall switch (not included) carrying the appropriate Install the ceiling mounting flange to cover any gaps which exist between the housing rating. One neutral (white), one ground (green or bare copper), and one hot (black lead and the finished ceiling.
  • Page 4 6” Metal Collar Assembly 5S5299100 Grill Springs 5S1202046 Grill 5S1202048 Ceiling Flange 5S1202050 Wire Compartment Assembly - AK200LS 5S1202615 Wire Compartment Assembly - AK280LS/AK300LS 5S1202052 Outlet Gasket 5S1202053 Installer: Installation Date: Place of Purchase: Model Number: www.airkinglimited.com A210572051 Rev. D 10-13...
  • Page 5 MODE D’EMPLOI Modéles : AK200LS, AK280LS, Ventilateur d’Évacuation AK300LS LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ. FAILLIR À SE CONFORMER AUX INSTRUCTIONS PEUT RÉSULTER EN BLESSURE PERSONNELLE GRAVE ET/OU EN DOMMAGE À...
  • Page 6 INSTRUCTIONS D’INSTALLATION Raccorder le conduit au collet de conduit du ventilateur (Figure 4). Fixer en place à l’aide de ruban ou de serre-joint. Toujours évacuer le ventilateur vers l’extérieur au AVERTISSEMENT : travers de chapeau mural ou de toit. Il est recommandé que les raccords d’extrémité VOUS ASSURER QUE L’ALIMENTATION EST COUPÉE AU basse de restriction sont utilisées.
  • Page 7 Posez le câblage d’un commutateur mural approuvé (non inclus) portant la spécification Installez la bride de montage au plafond pour couvrir tous les espaces qui existent appropriée. Un neutre (blanc), un de terre (vert ou cuivre dénudé), et un chaud (fil de entre le boîtier et le plafond fini.
  • Page 8 5S1202046 Grille 5S1202048 Bride du plafond 5S1202050 Assemblée du compartiment du fil - AK200LS 5S1202615 Assemblée du compartiment du fil - AK280LS/AK300LS 5S1202052 Joint - Extérieur 5S1202053 Installateur : Date d’installation : Endroit de l’achat : Numéro de modèle : www.airkinglimited.com...

Ce manuel est également adapté pour:

Ak280lsAk200ls