Publicité
Les langues disponibles
Les langues disponibles
EngLIsh
Problem
Solution
Unit will not start.
Check battery installation.
Check battery charging requirements.
Check that lock off is fully pulled back prior to moving main trigger.
Unit shuts down in use.
Charge battery.
Clear debris around spool.
Reduce/limit swath to 330 mm MAX.
Reinstall guard if it has been removed.
Battery won't charge.
Insert battery into charger until red charging light illuminates. Charge up to 8 hours if battery is totally drained.
Plug charger into a working outlet. Refer to Charger Operation for more details.
Check current at receptacle by plugging an appliance.
Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights.
Move charger and appliance to a surrounding air temperature of above 4 °C or below 40 °C.
Appliance runs slowly.
Fully depress the variable speed trigger. The level of trigger depression affects speed.
If appliance still runs slowly, remove battery from appliance.
Check that the spool housing can rotate freely. Carefully clean it if necessary.
Check that the cutting line does not protrude more than approximately 122 mm from the spool. If it does, cut it off so that it just
reaches the line trimming blade.
Trimmer is vibrating.
Make sure both cutting lines are the same length.
Check to see if the spool is properly wound. If spool is broken then replace spool.
40
TROUBLESHOOTING
Publicité
