Uline H-10825 Instructions De Montage page 2

3. Starting at the top of the side panels (A), slide front
panel (D) into channels on each side panel to form
the front of case. (See Figure 2)
NOTE: Front panel (D) should slide through the
side channels all the way to the bottom, where
it will rest in another channel on base (C).
Figure 2
A
C
4. Fit hinged top and back (B) on top of case with the
hinged door portion (contains magnet and molded
handle) covering the back. (See Figure 3)
NOTE: Magnets should match up on the hinged
door and the base (C).
Figure 3
PAGE 2 OF 6
ASSEMBLY CONTINUED
D
D
A
B
C
1-800-295-5510
uline.com
5. Align channel in hinged top and back (B) with
front (D) to secure front of the case. Front panel (D)
should fit securely into channels on all four edges.
(See Figure 4)
B
A
6. Side panels (A) should be on the outside of the top
panel (B). Secure with bolts (F) on the outside and
nuts (G) on the inside. (See Figure 5)
Figure 5
F
7. Open hinged door and slide in three trays (E).
(See Figure 6)
NOTE: Lightly tighten all screws to ensure
pieces are snug and case is stable. Do not
over-tighten.
Figure 6
A
D
Figure 4
G
B
E
A
E
D
E
C
0423 IH-10825