Pacvac Superpro 700 Serie Manuel D'entretien page 11

Product Specific Safety Instructions
1. WARNING Do not place the Superpro duo
700 model on the ground while the machine is
turned on. This can result in irreparable damage
to the motor.
2. The following models have a "A"-weighted
emission sound pressure level (at ear) of:
Superpro 700 - 67.5dB(A)
Superpro duo 700 - 76.6dB(A)
Superpro wispa 700 - 70.3dB(A) /
67.7dB(A) wispa mode
Superpro micron 700 - 69.8dB(A).
3. WARNING Only use the socket outlet on the
machine for purposes specified within these
instructions.
4. This appliance may be fitted with a power
socket outlet (excludes wispa 700 model).
A power socket outlet is designed for use
with applicably approved electric powerhead
attachments. Powerhead attachments use
rotating brushes to agitate carpet fibres in
order to dislodge dust and/or debris. Maximum
wattage for such attachment shall not exceed
200 watts.
5. Floor Tool and all purpose use Part No. FLT001
RETAIN THESE SAFETY INSTRUCTIONS FOR FUTURE USE.
Symbol Definitions
1. Attention!
Superpro 700 series
- Floor Tool is intended for vacuuming of dry
dust and debris off floor surfaces.
6. Part No. ACC001 - Dusting Brush is intended
for vacuuming of dry dust from blinds and other
delicate surfaces.
7. Part No. ACC002 - Crevice Tool is intended
for vacuuming of dry dust and debris from
crevices.
8. Part No. ACC003 - Upholstery Tool is intended
for vacuuming of dry dust from upholstered
surfaces.
Motor Thermostat
IMPORTANT:
The motor is equipped with a
thermostat. If for any reason, the vacuum cleaner should
over-heat, the thermostat will automatically turn the unit
off. Should this occur, turn off the switch and unplug the
vacuum cleaner from the electrical outlet and conduct
safety and maintenance checks. Allow the cleaner to
cool for approximately 30 minutes. To re-start, plug into
a power point and switch back on.
2. Operator's Manual; Operating Instructions
ENGLISH
11