Bruder Mannesmann Werkzeuge 12716 Instructions De Service page 9

•
Make sure that the crocodile clips do not touch one another once your charger is plugged into the mains –
danger of short circuit!
Additional safety measures
•
Avoid open flames, as charging lead-acid batteries generates flammable gases.
•
Always use the charger in a well-ventilated place. Do not use your charger in a vehicle or under a closed
bonnet or hood.
•
Do not cover the charger, this may lead to overheating and result in damages. Never set the charger up for
operation on a surface that is insulating (e.g. polystyrene). There is a risk of heat build up!
•
First, attach the crocodile clips to the battery terminals, then plug your charger into the mains.
•
To stop charging, first disconnect the power plug and then the crocodile clips from the battery terminals.
•
Do not allow any battery acid to reach your clothes or skin. If this should happen, rinse out the surfaces
affected with copious amounts of water. Immediately seek medical assistance if battery acid enters your eye.
Appliance description
1.
Power plug
2.
Black crocodile clip (NEG)
3.
Red crocodile clip (POS)
4.
Display
5.
Mode key
6.
Mains cable
Display
1. Battery voltage
2. Battery charge status
3. Motorbike charging program
4. Car charging program
5. 12 V charging program
6. Winter charging program
7. 6 V charging program
Fixed comfort connection
The coupling of the comfort connection is splash-proof. Therefore, the comfort
connection can remain permanently connected.
•
Attach the two eyelets to the terminal screws or to the corresponding
battery connections in the engine compartment or in the passenger cabin.
•
Ensure correct polarity: Eyelet marked in RED to PLUS, eyelet marked in BLACK to MINUS.
•
To connect the charging device, open the cover cap and connect the charger plug to the coupling. This is
possible in only one direction. (Reverse polarity protection)
•
After completion of the charging process, the coupling shall be closed with the cover cap.
Technical specifications
Operating voltage:
Output voltage:
Max. Charging voltage:
Charging current:
Ambient temperatures:
Housing IP class:
6V mode
220-240V AC, 50-60 Hz
6V DC
7.4 V
2,0 A
-5°C to +40°C
IP65
GB - 9
12V mode
220-240V AC, 50-60 Hz
12V DC
14.6V/14.8V
2,0 A / 4,0 A
-5°C to +40°C
IP65