Samsung MM-J320 Mode D'emploi page 17

Selecting EQ Mode
Your Micro Component System provides pre-
defined equalizer settings that are optimized for
particular music genre.
1. Press the EQ button.
Each time you press the EQ button repeatedly,
the mode will change as follows:
OFF;FLAT;RANCHERA;CUMBIA;REGGAE
;MERENGUE;SALSA;REGGATON
;FOLKLORE;PARTY;POP;HIP HOP
;ROCK;JAZZ;CLASSICAL;ELECTRONIC;P
OWER BASS
• The EQ button will be disabled during the recording,
and the product switches to " OFF" automatically.
• The equalizer mode may be different depending
on your region.
All manuals and user guides at all-guides.com
Software Update
Samsung may offer updates for the Product's system
firmware in the future.
If an update is offered, you can update the firmware
by connecting a USB device with the firmware update
stored on it to the USB port on your product.
Note that if there are multiple update files, you must
load them onto the USB device singly and use them
to update the firmware one file at a time.
Please visit samsung.com or contact the Samsung
Call Center to receive more information about down-
loading updates files.
• Select USB function, insert a USB device containing
• Updating firmware may not work properly if audio
• Do not disconnect the power or remove the USB
• After the update, all settings are reset to their factory
• Once the software update is completed, turn on
• Do not format the USB device in the NTFS format.
• Depending on the manufacturer, some USB devices
• The product has a DUAL BOOT function. If the
the firmware update into the USB port on the main
unit.
files supported by the product are stored in the USB
storage device.
device while updates are being applied. The main
unit will turn off automatically after completing the
firmware update.
default settings. We recommend you write down
your settings so that you can easily reset them after
the update.
If the firmware fails to update, we recommend
formatting the USB device in FAT16/FAT32 and
trying again.
the product with no disc inserted. The "NO DISC"
message appears on the display. Press and hold
the STOP button on the main unit for longer than 5
seconds. "INIT " appears on the display and the unit
powers off. The upgrade is complete.
The product does not support the NTFS file system.
may not be supported.
firmware fails to update, most functions will become
inoperable and "UPGRADE FIRMWARE" will appear
on the display. Update the firmware again.
17
English