Franke UNL-FW-304 Manuel D'installation page 8

EN
Installation steps
UNL-HO-304 /
UNL-HC-304
1. Remove mounting hardware from
faucet body shank.
2. Slide the Escutcheon (1) over the shank.
Make sure the Rubber Washer (2) is
positioned in its seat in the Escutcheon
(fig. 3A).
3A
1
2
3. Place the faucet in the hole, orienting
the spout towards the sink bowl
with the handles in position to rotate
forward.
4. Install mounting hardware to the
mounting shank underneath the
mounting surface in the following
order: Rubber Washer (3), Plastic Flange
(4), Fixing Plate (5) and Fixing Nut (6)
(fig. 3B).
3B
3
4
5
6
7 Nm
5. Tighten 2 screws in Fixing Nut (6) to
secure the nut (fig. 3B).
6. Screw in the 1/4" Push Fitting (8) into
the Hot Water Inlet (7) and screw the
3/8" Push Fitting (9) into the Cold Water
Inlet (10) (fig. 3C). Hand tighten only!
3C
7
8
9
Warning: Use of tools to tighten this
fitting can lead to leaks!
7. For the cold side, connect the 3/8"
poly-tube to the 3/8" Push Fitting
(fig. 1A, 1B) and connect the other end
of the tube to the filtration system
as outlined in the filtration system
instructions.
Note: There should be a service label
attached to the water supply pipes from
the faucet. Do not remove label.
8. For the hot side, connect the 1/4"
poly-tube to the 1/4" Push Fitting
(fig. 1A, 1B) and connect the other end
of the poly-tube to the heating tank
inlet as outlined in the heating tank
instructions.
8
10