Ayce NC800AG-125 Manuel D'utilisation page 46

2. Product symbols
In this manual and/or on the machine the following symbols are used. These
represent important information about the product or instructions on its use.
800 W
Rated output
800W
230 V~50 Hz
Rated voltage
230 V~
50Hz
11000/min
min
-1
Rotational speed
11000
125 mm dic
diameter
Ø 125mm
180726_ayce_NC800AG-125_IM
Recycle unwanted materials instead of
disposing of them. All appliances and
packaging should be sorted and tendered at a
regional recycling centre into to be processed
in an ecological manner.
Proven safety of the federal inspectorate for
heavy current installations ESTI.
M 14 spindle
M 14
3 positions handle with soft
start
3M
3 m cable with Swiss plug
OPERATION
1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. They should fit with the machine and your
purpose.
2. Functions
a. Fitting the guard (Fig. 1)
Switch off the grinder and disconnect it from the power supply.
!
Depending on whether your operation is cutting or grinding, select the
correct disc guard.
WARNING
Fig. 1
b. Changing the cutting disc (Fig.2)
CAUTION: Always ensure that the tool is switched off and unplugged from the power
supply before making any adjustments, carrying out maintenance or changing a disc.
Turn the angle grinder on to its back, press the spindle lock button and rotate the
spindle until it locks.
90 91 |
• This tool is supplied with both
grinding and cutting guards. Please
take time to refer to the diagrams in
this manual to ensure you are using
the correct guard for the task. Failure
to use the grinding guard for cutting
operations could result in injury. This
guard has been specifically designed
to offer extra protection in the rare
event of disc or work-piece failure.
Use of the grinding guard offers extra
versatility in confined spaces but
must only be used for grinding.
• Open the cam lock mechanism of the
disc guard. Position the guard on the
tool.
• Twist the guard to the appropriate
position, where it will deflect hot
sparks away from the operator.
• Lock the guard in position with the
cam lock.
180726_ayce_NC800AG-125_IM
GB