Bosch TDA302801W Notice D'utilisation page 17

The descaling liquid may be purchased from our
after-sales service or specialist shops.
Name of accessory: TDZ1101
D anti-calc*
The "anti-calc" cartridge has been designed to
reduce the build-up of scale produced during
steam ironing, helping to extend the useful life of
your iron. Nevertheless the "anti-calc" cartridge
cannot remove all of the scale that is produced
naturally over time.
Trouble shooting
Problem Probable cause
The iron does not 1. Temperature control (12) set to
heat up.
2. The "secure" system has been
3. The "SensorSecure"* system has
The clothes tend 1. The temperature is too high.
to stick.
Water drips out of 1. Temperature control (12) setting is
the soleplate (7)
together with
steam. 2. Steam regulator (3) is set too high in
3. You have pressed the shot of steam
Steam does not
1. Steam regulator (3) is set to
come out.
2. The temperature is too low. Anti-drip
Smoke comes out 1. This may be caused by the
when connecting
the iron for the first
time.
Excessive dripping 1. No proper closing of "Calc'nClean"
or steaming.
1. Traces of lime scale are coming out
Deposits come out
through the holes
in the soleplate
(7).
If none of the above solves the problem, get in touch with an authorised technical service.
* Model dependent
minimum.
activated ("auto off" indicator light
15* flashes). The iron is set to
stand-by.
been activated ("SensorSecure"
indicator light 16* flashes). The iron
is set to stand-by.
too low.
conjunction with a low temperature.
button (2) repeatedly without waiting
for 5 seconds between each press.
position.
system is activated.
lubrication of some of the internal
parts.
system.
of the steam chamber.
Solution
1. Turn to a higher position.
2. To reconnect the iron, just move it
about gently.
3. Grip the handle of the iron to re-start it.
1. Turn the temperature control (12) down
and wait until the iron has cooled down.
1. Turn the temperature control to a higher
setting (between "••" and "max") and
wait until the pilot light (13) goes out.
2. Set the steam regulator (3) to a lower
setting.
3. Wait 5 seconds between each press of
the shot of steam button.
1. Set the steam regulator to a higher
[ ]
position.
2. Set to a higher temperature if
compatible with the fabric.
1. This is normal and will stop after a few
minutes.
1. Actuate a few times the "clean" button
(10).
1. Carry out a cleaning cycle (see
"Calc'nClean" section).
17
BOS CH