Publicité
Les langues disponibles
Les langues disponibles
The power supply must match the technical
specifications of the power tool, and it must be
grounded.
The power cord must be plugged into a socket with
differential protection. The circuit breaker must be set to
trip when there is a maximum fault current of 30mA.
Do not expose the power tool to rain or use it in wet or moist
environments. The presence of water in a power tool
increases the risk of damage and electric shock to the user.
Never use the power cord to pull, carry or unplug the power
tool. Damaged power cords increase the risk of electric
shock.
Keep the power cord and plug away from heat sources, oil
and sharp objects.
Check the condition of the power cord regularly, if it is
damaged, it must be replaced or repaired by a qualified
technician. Do not touch it and unplug it immediately.
Never use the power tool with a damaged power cord.
Never change the power cord plug and use a socket which
is compatible with the plug. Do not use any kind of socket
adaptor.
If the power cord is too long, the electric current may drop,
causing a decrease in the quality of the welding. The
tension must be kept stable.
The use of extension cords to plug the power cord is not
recommended. However, if you use an extension cord, you
should take some precautions, such as:
▪ If you use the power tool outdoors, use only extension
cord suitable for outdoor use. The use of a suitable
extension cord reduces the risk of electric shock;
▪ The cross-section of the extension cord's cables shall be
proportional to the length and with the same
characteristics as or larger than the welding machine's
power cord;
▪ Do not use damaged extension cords. Examine the
extension cords before using them and replace if
necessary;
▪ Always unplug the extension cord before removing the
plug from the power tool;
▪ When using an extension cord reel, unroll the cord
completely.
Individuals who have not read the instruction manual and
are not familiarized with how to operate the welding
machine must not use it. Welding must be carried out by
qualified personnel who are aware of all the associated
safety precautions.
Before welding, remove solvents, degreasers and other
combustible materials from the work area.
Ensure
that
ambient
concentrations of dust, acid vapours, gases or flammable
substances. We recommend special care when performing
repair work on pipes and containers that contain or have
been in contact with combustible liquids or gases.
To ensure that you work with the power tool safely, you
should take into account a few precautions and procedures
before start-up:
▪ Check that the attached accessories are assembled
correctly and in good condition. Never use damaged
accessories;
▪ Replace defective or damaged parts as well as all other
used and worn out parts;
▪ Check that the safety devices are in perfect condition
and work properly. Never use the power tool if the safety
devices are missing, inhibited, damaged or worn out.
Make all adjustments and work necessary for the correct
assembly of the power tool if you have any questions or
difficulties, contact your official dealer.
air
does
not
contain
high
Publicité
