Sinbo SHC 4348 Mode D'emploi page 7

All manuals and user guides at all-guides.com
1. Cutting head 4. Charging stand
2. On/off switch 5. Control lamp
3. Charge Points 6. Clip-on comb attachment
PREPARING FOR USE
1. The appliance as supplied by the manufacturer is not yet
ready for use.It must be electrically charged prior to use.
2. Insert the plug of the battery charging stand 4 into a
socket.Warning! This appliance must be charged at the specified
voltage! You can store the remainder the charging 4
(220V50Hz/60Hz).In order to charge the appliance it should
be placed in the battery charging stand 4 so that the control
lamp 5 lights up.While the appliance is being charged, the switch must be set at"0"(the
"0"must be visible).A charging period of 16hours is required before initial use.Take
care to keep the charging contacts 3 clean as soiled charging contacts can interfere
with the charging process Overcharging of the appliance is not possible.
3. After charging the appliance is ready for use.It can be used with or without the clip-
on comb attachment.To attach the clip-on comb attachment,slide it onto the cutting
head1 until it clicks into postion.The appliacne must be switched off while the clip-on
comb attachment is being attached or remove.
4. The clip-on comb attachment is easily adjustable .Simply slide it up or down the
cutting head1.The hair can be cut to 4different lenghts ranging from approximately
3mm to 6mm.The postion of the clip-on comb attachment on the cutting head determines
the length of the haircut.
5. After using the appliance,switch it off and replace it in the battery charging stand
4 to be recharged-the control lamp 5 must light up.In order to retain the load capacity
of the storage battery we recommend to use the storage battery until it is empty before
reloading.
PARTS DESCRIPTION
- 6 -