Publicité
Les langues disponibles
Les langues disponibles
Problem
Red and green LEDs
do not illuminate to
indicate the Battery is
correctly charging
Battery Pack has low
Capacity
Impact Wrench
cannot be switched
on (Trigger Switch (5)
does not move)
Impact Wrench does
not start when trigger
switch is depressed
Troubleshooting
Possible Cause
Battery not correctly
connected to Charger
Charger not Powered
Battery not being fully
charged
Battery pack has
been charged over
100 Times and
Capacity has started
to reduce
The forward/ reverse
Switch may be in the
middle Position
('locked')
Battery completely
discharged
Defective Battery
Tool defective
23
Solution
Clean Battery Socket
of charger and battery
contacts and fully
slide on to Charger so
it clicks in a locked
Position
Recheck Mains
Connection
Do not remove
Battery until a full
Charge is indicated
This is normal for
Battery packs.
Contact Westfalia
purchase a replace-
ment Battery Pack
Slide the For-
ward/Reverse Switch
either to the left or
right
Recharge Battery or
replace with a fully
charged Battery
Replace Battery
Contact the Westfalia
customer service
Publicité
