Westfalia ASS 18 Manuel D'instructions page 22

Intended Use
Battery operated general-purpose impact driver, suitable for light to
medium duty tasks, driving nuts and bolts.
Unpacking Your Tool
 Carefully unpack and inspect your impact driver. Familiarise yourself
with all its features and functions.
 Ensure that all parts of the tool are present and in good condition. If
any parts are missing or damaged, have such parts replaced before
attempting to use this tool.
Before Use
Please note that that battery and charger are not included with the
tool.
Removing the Battery
To remove the battery (8) from the impact driver, press the battery
release button (9), then slide the battery off the hand grip (6).
WARNING: Do not try to remove the battery without pressing the
battery release button. The impact driver or battery could be damaged.
Fitting a Battery
To fit a charged battery, slide it on to the hand grip (6) of the impact
driver until it clicks and locks into position.
Note: Make sure the battery and impact driver are lined up correctly. If
the battery does not slide into the impact driver easily, don't force it.
Instead, slide the battery out of the impact driver again, check the top of
battery and the impact driver battery slot are clean and undamaged and
that the contacts are not bent.
Setting up the Battery Charger
(Battery and Charger not included)
1. If fitted, remove any battery from the battery charger.
2. Insert the battery charger mains plug into a suitable mains socket.
Note: The green LED on the battery charger will blink to indicate that
the battery charger is ready to charge the battery.
Operation
18