Publicité
REPLACEMENT OF HANDLE WITH NIGHTLIGHT
Note: Nightlight of the replacement handle will only work on cabinets that were originally equipped with nightlights.
Pro-tip: If the Uplift Tech Handle kit is being upgraded at the time of install, it is recommended to install the new handle prior to
installing the front mirror in order to save a few steps.
1. If the front mirror installation is complete, start by removing the four mirror screws holding the front mirror assembly as shown in
Image 1B. The mirror does not have to be removed.
2. Swing the bottom of the mirror outward just slightly, and disconnect the connector as shown in Image 2B. Let the mirror rest in place.
3. Remove the four handle screws located on the back of the handle as shown in Image 1B. The removed handle is no longer required.
4. Swing the bottom of the mirror out similar to Step 2, and reconnect the connector as shown in Image 2B.
Handle and Mirror Screws-071819.pdf 1 7/19/2019 11:20:08 AM
5. Place new handle in the same position as the original with the mounting flange behind the door frame, and re-install the handle
screws that were removed in Step 3.
6. Inspect the functionality of the handle nightlights by pressing the nightlight button on the column.
7. Re-install the four mirror screws that were removed in Step 1 as shown in Image 1B.
1
C
M
Y
CM
MY
CY
CMY
K
2
© 2019 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
1B
Note: View is from inside the Cabinet for screw location
Handle Nightlight Wiring-071819.pdf 1 7/18/2019 5:43:00 PM
Handle screws
2B
C
M
Y
CM
MY
CY
CMY
K
Nightlight Connector
2
Handle screws
Mirror screws
Part no. 209-1315-A rev. 08/21/19
Uplift Tech Handle
Publicité
