Bimar HOTECH S603.EU Notice D'instructions page 28

All manuals and user guides at all-guides.com
1.5 RESET FACTORY SETTINGS
1. Touch " ", touch once again and keep pressed "
symbol " " blinks fast.
2. Put the side switch to position 0.
Disconnect the plug from the power socket and leave the heater unplugged
for 30 seconds.
Insert the plug in the power socket and turn the side switch to position I.
1.6 DESCRIPTION OF THE CONTROL PANEL SCREEN OF THE
SMARTPHONE
Use through a smartphone
Follow the procedure in paragraph 1.1.
•
When the control panel appears you can start using the
device through your smartphone (see to side).
•
= symbol in the control panel representing
ambient temperature of the room the heater is installed.
•
Touch " " on the smartphone to activate the 800W
resistor of the heater, the symbol "
heat will appear on the smartphone screen
•
Touch " " to adjust power levels:
- 1200W on the device display corresponds to the symbol
" "=comfortable heat on the smartphone screen.
- 2000W on the device display corresponds to the symbol
" "=immediate heat on the smartphone screen.
- 800W- on the device display corresponds to the
symbol " "=anti-frost function on the smartphone
screen.
•
Touch " " on the smartphone if you want to activate the fan, touch it again to turn
it off .
•
Touch " " or "
heating element is only activated when ambient temperature is lower than set
temperature.
•
To put the heater in stand-by mode, touch "
off (when unused for long periods of time) put the side switch to position 0 and
unplug the device.
" =low consumption
" on the smartphone to adjust ambient temperature; the
" on the smartphone; to turn the heater
28/84
" until the connection