Publicité
Les langues disponibles
Les langues disponibles
1. TECHNICAL CHARACTERISTICS
Technical characteristics: Powered by
4 AA 1.5V alkaline batteries. Do not use
rechargeable batteries.
Opening code from 3 to 8 digits + A or B.
It has an emergency security lock. Never
keep keys inside the safe.
Before any performance, carefully read
the instructions. Carry out all checks
with the door open. Verify the correct
operation before proceeding to close
and install your safe.
2. FIRST USE
The safe comes open, remove the
seal from the latches and place 4 AA
alkaline batteries in the interior battery
compartment. Next, program your opening
code.
3. PROGRAMMING THE CODE
Press the button located on the back of
the door, you will hear two beeps and the
yellow LED will light up.
Then enter your 3-8 digit code followed
by A or B. Check the combination before
closing.
4. OPENING / CLOSING
To open, dial the combination followed
by A or B. With each press you will hear a
beep and the yellow LED will light up. If the
combination is correct, the green LED will
light up, then you can turn the knob to the
right and open the door. To close, turn the
knob to the left.
5. EMERGENCY OPENING
Your safe has an emergency lock to open
in the event of an electronic anomaly,
exhausted batteries, or forgetting the
combination.
The
located
between
keyboard, hidden under a cover. Remove
the cover and insert the emergency key.
Turn the key, turn the knob and open the
door.
Very important: Do not keep emergency
keys inside the box. There are no duplica-
te emergency keys.
ENGLISH
emergency
lock
the
knob
and
the
6. OBSERVATIONS
Wrong code: If the code entered is not
the one previously programmed, the yellow
LED will flash and you will hear a special tone
indicating that this code is not correct.
Lock: By entering a wrong code 3
consecutive times, the safe is locked for
20 seconds. If after this time you enter
another 3 wrong codes again, it will be
blocked for 5 minutes.
Low batteries: If when making an opening,
together with the green LED the red LED
lights up, it means that the battery level
is too low. Please in this case immediately
replace all 4 batteries with 4 new alkaline
batteries.
Battery change: The battery holder is
accessed from inside the box, on the back
of the door. The battery holder is located
under a cover. Open the cover and change
all four batteries (do not leave any old
batteries). Dispose of used batteries in
an environmentally friendly manner. Close
the lid again and verify correct operation
before closing.
This product should not be
thrown in the trash. It must be
disposed of at public recycling
and collection points.
EU DECLARATION OF CONFORMITY
BTV SL
Polígono Industrial BTV-Alfindén,
Ctra. Nacional II, Km., 333, 50171
La Puebla de Alfindén, Zaragoza
is
CIF: B50078682
We hereby inform you that the product
MINIBANK SAFE
It has been manufactured in accordance with the
provisions of current regulations for marketing and
commissioning in the European Union.
Zaragoza, August 09th023 - BTV, S.L.
3
Publicité
