Elditest CT4025 Mode D'emploi page 4

All manuals and user guides at all-guides.com
Hands, shoes, floor and work bench
must be dry.
Avoid making measurements under
humidity, dampness or other
environmental conditions that might affect
safety.
Turn the high voltage source off before
connecting or disconnecting the probe
whenever possible.
The probe body should be kept clean
and free of any conductive contamination.
Do not remove the probe casing.
Removal of the probe's casing may expose
you to electric shock.
Keep fingers behind the probe's finger
guard during use.
Always properly ground the probe with
the lead before contacting high voltage
circuits with the probe tip. Always
disconnect the probe tip from high voltage
circuits before disconnecting the ground
lead. Do not connect the probe ground lead
to any point which is at a potential other
than earth ground.
Use only on test instruments where the
chassis or return lead is properly
grounded.
3
187 information
www. .com