Publicité
Les langues disponibles
Les langues disponibles
72" (182.9 cm) –
78" (198.1 cm) to
Floor (Typical)
Bath/Shower
Installation
10"
(25.4 cm)
4" (10.2 cm)
72" (182.9 cm) –
78" (198.1 cm)
to Floor (Typical)
48" (122 cm)
to Floor
Shower Installation
3. Install the Valve
Install the valve on the support framing so the "UP" mark on the
valve is facing upward.
Install elbows and adapters (if needed) to 1/2" copper tubing or
1/2" pipe of proper length. Apply thread sealant, and connect the
piping to the bath and shower outlets of the valve.
Connect the water supplies to the valve body using elbows, 1/2"
copper tubing or pipe, and adapters (if needed). Use thread
sealant on all threaded connections.
IMPORTANT! Secure the piping to the framing.
Temporarily install 1/2" nipples to the bath and shower elbows
so they will extend at least 2" (5.1 cm) beyond the finished wall.
If you removed the inner valve components for soldering,
carefully reinstall them now.
114489-2-BA
Shower Ell
1/2" Copper
or Pipe
1/2" Adapter or
Solder Direct
Shower Outlet
Hot Side
1/2" Copper
or Pipe
Bath Outlet
1/2" Adapter or
Solder Direct
Bath Ell
6
Kohler Co.
Publicité
