Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL & SIDE BUTTON FUNCTIONS | EN
Flow (adjust water flow)
The water flow can be adjusted under the rear / bidet clean-
ing mode. The pre-set flow is high water flow pressure. To
decrease the water flow intensity - press the - button to the
side of the flow button. There are 3 water flow pressure set-
tings - high pressure / medium pressure and low pressure. The
corresponding light indicates the chosen option.
Seat (adjust temperature)
The heated seat function starts when you sit down and press
any cleaning mode. The pre-set temperature level is high. To
decrease the seat temperature level - press the - button to the
side of the seat icon. There are 3 temperature levels - high /
medium / low. The corresponding light indicates your chosen
option.
Important note
For children and adults with sensitive skin - Please adjust the
seat temperature to medium or low temperature. To prevent
user scalding - the system will automatically decrease the seat
temperature after being seated for longer than 15 mins.
Side button functions:
Cleaning modes
Press the rear / bidet cleaning function buttons to start. To
stop function - press button again.
Press the drying button to start. To stop function - press the
button again.
Automatic cleaning mode (preset program)
Slide & hold the rear / bidet cleaning function button for more
than 2 seconds to begin a preset cleaning mode. This preset
regime has the following steps; Back and forth rear /bidet
cleaning mode - 30 seconds. Back and forth powerful massage
- 60 seconds. The preset cleaning mode stops when the last
step is finished after 3 minutes 30 seconds.
Night light
The night light is preset and will automatically turn on when
the bathroom has no light. To turn off this function - slide and
hold the rear cleaning function for more than 5 seconds to
turn off the preset night light. To turn the night light back on -
repeat the above.
Under rear/front cleaning mode push the side button forward
to adjust the position of the nozzle or water volume. Hold the
drying button more than 2 seconds to switch between nozzle
position or water volume adjustments. When you hear the
sound you have successfully switched modes.
Under the drying mode push the side button forward to set
the temperature lower or higher.
9
Publicité
