BEMIS PURE CLEAN 2000 Notice D'installation page 11

WATER FILTER CLEANING
1. Pull out the power supply cord and make
sure to close the water infl ow connecti on.
3. Gently clean the fi lter screen.
NOZZLE CLEANING
1. Press the Rear-cleaning &
Bidet Butt on for 2 seconds to
make the nozzle extend out
of the seat then remove the
nozzle.
WATER FILTER & NOZZLE CLEANING | EN
2. Detach the water inlet hose from the
seat and take out the water infl ow fi lter.
4. Place the fi lter back into the seat. Re-con-
nect the water hose and open the water
valve. Press the reset butt on aft er
connecti ng the power supply cord.
2. Gently clean the nozzle
with a toothbrush, soft
sponge or smooth cloth with
soap or mild detergent.
3. Place back the nozzle
and press either the Stop
butt on or the Rear cleaning
and Bidet butt on again for 2
seconds the nozzle will then
automati cally retract back
into the seat.
11