Publicité
Les langues disponibles
Les langues disponibles
Installation
Frame and Bowl Assembly
2
When installed properly, the basin will be level and flush to the back wall.
For clarity, the pre-mounted soap spout, faucet spout,
dryer hood and air hoses are not shown.
Position the basin
onto the frame. The
A
right vertical frame
support will fit into
the basin notch as
shown.
Use the back
basin flange
as a template
to mark the
(2) mounting
hole locations
onto the wall.
After marking
the wall, install
suitable wall
anchors. See
step 1b.
Drain and P-Trap
3
Use ⁵⁄₆₄" hex driver to
D
install screw to drain
cap assembly.
Drain Cap Assembly
(S45-2714)
Assembly o-ring, drain
B
adapter and packing
washer to basin hub
with (4) #10 screws.
Do not overtighten the
screws on the drain adapter!
Bradley • 215-1773 Rev. G; ECN 15-08-006
Secure the basin flange
B
to the back wall using
suitable
" fasteners
³⁄₈
supplied by the installer.
O-Ring
(125-111)
Packing Washer
(142-135)
#10 Screw
P10-225
P-trap
C
For clarity, the soap spout, faucet spout, dryer
hood and frame are not shown.
Drain Adapter
(111-091)
P-Trap Outlet
C
Attach p-trap to
outlet and drain.
4/20/2015
Access the basin
flange through the
dryer hood access
hole. See Step 5 for
more information on
how to remove dryer
hood cover and how
to disconnect the
upper plenum hoses
for access to the
basin flange.
Secure the bowls to the frame
with the six ¼"-20 x
" screws
³⁄₈
(p/n 160-389) and washers
(p/n 142-002DB) provided.
A
Install p-trap outlet to
stub out from wall.
AV90
11
Publicité
