Publicité
Les langues disponibles
Les langues disponibles
HOW TO USE
Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
Vornado Air LLC at 1-800-234-0604.
1. Use integrated handle on top of heater for
lifting and carrying.
2. Position heater so airflow is not obstructed.
3. Unwrap power cord from storage tray on back
of heater. Plug power cord into standard
grounded wall outlet.
4. Press the Power button
and select Mode or
Fan Only
. Room temperature will illuminate
on both displays. Set thermostat to desired
temperature using -/+. SET TEMP numbers
will flash on both displays as you adjust.
Once the selection is made it will flash for five
seconds, become constant for five seconds
and then returns to room temperature. The
displays will then dim after 20 seconds. Default
settings upon first use will be High Heat and set
temperature of 75 degrees.
5. Set timer to automatically power the unit off by
pressing
. 0 will flash on both top and front
displays. Press
to select the amount of time in
10 English
REMOTE CONTROL
Screwdriver required.
Your VMH500 heater remote includes (1) coin-style CR2032 battery. Battery comes pre-installed. Remove battery pull tab before first use. The
remote is wrapped inside a polybag and packed in the top of the product inside the retail carton.
one-hour intervals, up to 12 hours. User can also
1. For battery replacement, the remote
use -/+ to select the amount of time.
After a selection is made or after five seconds
of inactivity, the number selection will stop
flashing and become constant. It is then
2. To replace battery, open battery door
displayed for five seconds, before room
temperature is displayed again. To cancel the
timer operation, select 0 hours or hold
for
three seconds.
The white indicator light on front display and
TIMER on top display will illuminate to indicate
the timer is on.
COOL DOWN
When you power off your heater while in
High or Low heat mode, it automatically
enters a cool down routine in which the
heating element turns off and the fan
exhausts remaining heat. During Cool
Down, both top and front displays count
down before powering off completely.
requires one coin-style 3V CR2032 battery.
Always use the correct size and grade of
battery for this product.
on the back side of the remote control
(you will need to loosen the small screw
on door using a #1 Phillips screwdriver
- screwdriver not included). If necessary,
clean the battery contacts and also those
of the device prior to battery installation.
Remove any plastic protection from the
battery and place it in the remote with the
+ side facing up. Replace the battery door
and screw.
Note: Remove battery from the remote
control when not in use for an extended
period of time and always remove dead
battery immediately and replace with
fresh. Do not store dead battery in remote.
3. Your remote control will operate the
same as the control functions located
on the heater, except when changing
POWER
modes. When changing modes, both
displays will show either LO, HI or FA
THERMOSTAT -/+
on the display as you cycle through.
Once the selection is made, it will
MODE
hold for eight seconds before room
High Heat (1500
temperature is displayed again.
watts), Low Heat
(750 watts) or Fan
The remote requires a line-of-sight path
Only.
to allow for the signal to be received
by the heater. Position the heater so
TIMER
the receiver lens (inside the display
on front of heater) is visible from the
remote control.
CAUTION: DO NOT
INGEST BATTERIES.
English
11
Publicité
