Warm Tech TCPM2000TVTIM Notice page 16

Convector heater with thermostat, timer
and fan "TCPM2000TVTIM"
All the above instructions for models
"TCPM2000THERMO" and "TCPM2000T"
and "TCPM2000T" also apply
to model "TCPM2000TVTIM"
4
WALL MOUNTING

The heater is supplied with 4 off
each fixing brackets, screws and
plastic wall plugs to enable it to be
mounted onto a wall if required.

If it is decided to mount the heater
on the wall, the feet should not be
fitted. The position must be chosen
carefully.

It must not be in front of or below a
power socket.

It must not be below a shelf,

curtains or any other obstruction.
Also refer to the safety instructions
overleaf.

Having decided on the location of
the heater it is necessary to drill 2
fixing holes 8mm diameter by
43mm deep at 486mm centres on
a horizontal line at a minimum
height of 400mm from the floor.

Allowance must be made for any
floor coverings, carpet etc and if
any skirting boards are present, the
fixing holes must be a minimum of
400mm above the top edge of the
skirting board.

Using the plastic plugs and fixing
screws provided, attach 2 of the
fixing brackets to the wall.

The other pair of fixing brackets
must be attached to the base of the
heater using the feet retaining
screws so that the brackets project
out at the rear of the heater and
space the bottom edge away from
the wall.

If required, these brackets may
also be secured to the wall using
the remaining fixing screws and
plastic wall plugs.

If this option is chosen it is
suggested that the heater is hung
All manuals and user guides at all-guidesbox.com
Always un-plug the heater from the wall
socket and allow it to cool down before
cleaning.
Clean the outside of the heater by wiping
with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives
and do not allow any water to enter the
heater.
When the heater is not used for long
periods of time it should be protected from
dust and stored in a
clean dry place.
Refer to the enclosed guarantee
conditions for the terms and conditions of
guarantee
environmentally safe way.
on the upper brackets and the hole
positions for the lower brackets is
then marked on the wall, prior to
drilling the holes for attachment
purposes.
5
CLEANING THE HEATER
6
STORING THE HEATER
7
GUARANTEE
8
ENVIRONMENT
Should your machine need
replacement after extended use,
do not put it in the domestic
waste but dispose of it in an
WARM TECH
81, rue de gozée
6110 Montigny-le-Tilleul
Tél : 0032 (0) 71 29 70 70
Fax : 0032 (0) 71 29 70 86
Belgique
2007
16