Publicité
Les langues disponibles
Les langues disponibles
EN
2. If needed, place the protective strip on the clamp as shown. Attach clamp to the
mounting support, then refit the locking screw, ensuring it goes through the hole in
the clamp. Do not tighten the locking screw.
Assemble the support into the bar
1.Place the plastic sealing strip into the bar. Pull down on the
red button, then adjust the height of the fixing, so it can be inserted into the bar.
2.Fit the rubber pad onto the support, ensuring it fits into the holes underneath the
foot.
-3-
Publicité
