Publicité
Les langues disponibles
Les langues disponibles
8. Screw the Mounting knob (10) into the
threaded screw (16).
9. Pre-tension the saw chain (12) by turning the
screw for the chain quicktensioning system (8)
in the direction.
10. Tighten the mounting knob (10) of the sprocket
cover (
).
Caution! The pruner saw can be prone
to leaks.
Prior to changing the saw chain, the groove of
the guide rail must be cleaned of dirt because
dirt deposits available can cause the saw chain
to break out of the rail. The deposits can also
absorb the chain oil. So the consequence would
be that the chain oil would not or only a small part
of it would reach the underside of the rail and the
lubrication would be reduced.
Tensioning the saw chain
Regularly tightening the saw chain provides safety
for the user and reduces and/or prevents wear
and chain damages. Before the start of work and
in approx. 10 minute intervals, we recommend the
user to examine the chain tension and correct it,
if necessary. The chain warms up when working
with the saw and thus expands slightly. These
"expansions" can be expected especially from
newer chains.
Do not re-tighten or change the chain
when it is hot because it shrinks slightly
once it has cooled down. In case of non-
observance, this can lead to damages on
the guide rail or the engine because now
the chain is too taut on the blade. Chain
tension and chain lubrication have a
significant impact on the service life of
the chain.
The chain is correctly tensioned if it does not
sag at the rail underside and can be rotated
completely around with the gloved hand. When
the saw chain is tensioned with 9 N (approx. 1 kg),
the gap between the saw chain and the guide rail
may not be more than 2 mm.
10 min
9N max. 2 mm
10
Switch off the device and remove the
battery before carrying out any
maintenance work.
1. Loosen the mounting knob (10) of the sprocket
cover (9) (
).
2. To tension
the saw chain, turn the screw
(8) for the chain quicktensioning system in the
direction. To loosen
screw (8) for the quick-tensioning system in
the direction .
3. Tighten the mounting knob (10) of the sprocket
cover (9) again (
The chain tension of a new saw chain
must be readjusted after a maximum of 5
cuts.
Removing/inserting the rechargeable battery
1. To insert the battery (14) into the device,
push the battery along the guide rails into the
device. You will hear them click into place.
2. To remove the battery (14) from the device,
press the release button (14a) on the battery
and pull the battery out.
4. OPERATION
Switch on the chainsaw only when chain
bar, saw chain and sprocket chain wheel
covering are correctly assembled.
Make sure you have a secure stance.
Before starting, ensure that the electric
chainsaw is in contact with no objects.
Never operate the device without the
front cut protection. Risk of injury!
Switching on
1. Place the battery (14) into the device
2. Check the load status of the rechargeable
battery before starting.
3. Hold the device firmly with both hands, with
your right hand on the handle (5) and left hand
on the grip (2). Your thumb and fingers must
tightly clasp the handle (5). Never use the
device onehanded. Risk of injury!
4. To turn on, press the switch lock (3) with your
thumb or index finger and then press the on/
the tension, turn the
).
Publicité
