AL-KO Snow Line 560 II Mode D'emploi page 30

GB
Changing the wheel drive speed
1. Release (disengage) the auger and wheel drive
clutch levers ( 38-1).
Change the drive speed only when disengaged
2. Change the drive speed using the speed selector
( 38-2).
Unclogging the snow discharge chute
If snow does not discharge properly, the augers or
1. Release (disengage) the auger and wheel drive
38-1).
clutch levers (
2. Switch off the engine.
3. Disconnect the spark plug connector.
4.
chute and auger using the snow cleaning tool
( 39-1).
If snow still does not discharge properly, contact a quali-
Maintenance and care
Danger - risk of injury!
always switch off the engine and disconnect the
spark plug connector.
Do not hose down the unit with water!
Replace the silencer if defective.
Maintenance schedule
Before each use
30
All manuals and user guides at all-guides.com
Every three months
Annually
Lubricating the auger
Using a grease gun, inject 2 to 3 shots of universal
grease into the grease nipple (
Maintaining the wheel drive
Adjusting the control cable
If the wheel drive no longer engages when the engine is
1. Loosen the lock nut (
2.
3. Tighten the lock nut.
4.
5. If the wheel drive still does not engage and
Check the shear pins.
Check the tyre pressure.
Lubricate the snow discharge chute ring with
spray oil ( 11).
Lubricate auger.
Caution!
Switch off the engine before adjusting the con-
trol cable.
41-1).
direction of the arrow ( 41-2) until the control
the clutch lever is pressed. Hold the cable while
tightening so that it does not twist.
engaging the wheel drive.
Translation of original user instructions
AL-KO snow blower
40).
-