Publicité
How to use the Interchangable
Blow Dry Brush
HOW TO FIT, ATTACH & DETATCH YOUR
ATTACHMENTS:
Simply hold down the release button and
place the attachment into the handle on a
45-degree angle.
Keeping the release button down, turn/rotate
the attachment anti-clockwise till you cannot
turn it anymore and it is in position.
To remove, simply hold down the release
button and turn clockwise 45-degrees.
Be sure to not touch the attachments when
hot and always use the cool tip to handle as
the barrel will get hot after use.
STEP ONE:
The Mermade Blow Dry Brush is suitable for
towel dried, damp or dry hair.
Do not use on soaking wet hair. Hair must be
75% dry. Slide the button up to turn on and
select the desired settings. The red light will
indicate 'ON'.
1.
Cool – Low heat, high power
2.
Low – Medium heat, low power (best for
thin/fine hair)
3.
High – high heat, high power (best for thick
hair)
STEP TWO:
Dry off your roots and ends with the "PRE-
STYLE" DRYING ATTACHMENT.
It is important to dry off the hair so it is 75%
dry before using the brush attachments.
The drying attachment is not designed to
replace a hair dryer.
Got questions? Email us at hello@mermadehair.com
STEP THREE:
Start by dividing hair into 2-inch sections
with our Grip Clips. Apply heat protectant
spray to each section.
Start with the 60MM/1,25 OVAL BARREL the
oval brush near the root, brush slowly away
from the head. Continue doing this to
remove moisture and dry each section. Then,
place the brush at your ends and roll the
brush up the length of your hair until the
barrel is at your roots, wrapping the hair
around the brush in the process.
Wrapping the hair around the barrel will give
curve and bounce. Twist the hair as you
unravel the brush. Repeat this process for all
layers and sections of hair. For extra volume,
apply the brush under each hair section &
hold for a few seconds.
STEP FOUR:
Use the 32MM/2.4 INCH CURLING BARREL
to create extra curl in the hair. Wrap the hair
up so the hair is flat and even (this will ensure
it doesnt get stuck). You can also wrap the
hair and then twist the hair out of the barrel
as you turn the brush. Watch our website for
a tutorial.
Add extra curl to your bangs, fringe or ends
by wrapping the hair around only one time
and holding it on the heat to set.
Set with the Cool (low heat) function.
STEP FIVE:
Once you have finished drying your hair,
slide the button down to 'OFF'. Allow the
Blow Dry Brush to cool down completely
before stowing away.
Publicité
