BluMill SDT-1004HI Mode D'emploi page 5

ASSEMBLY INSTRUCTIONS
EN
8
Parts: Gather all Curved Frame
with T-Section Lay out the Curved
Frames in the
ground as shown in the picture
with the spring openings facing
the floor.
Slide all Curved Frames onto
each other to complete a full
circled frame.
Attach the Leg Extensions to
all T- Section with the horizontal
opening facing the inside of the
frame.
Place the "U" Shaped Legs with
the openings aligning to the hori-
zontal opening from the Extensi-
on Leg.
Once all "U" Shaped Legs have
been installed, align the T-Sec-
tions from the Frame and slide
until all have assembled legs are
secure.
EN
Place the Trampoline Mat in
the middle of the frame , with
the logo facing upwards and the
stitching facing the floor.
LEARNING TO INSTALL
SPRINGS
Install the Spring by placing the
"R" Hook on the V-Ring of the
Trampoline Mat.
Using the Spring Tool, pull the
"C" Hook until it reaches the
opening in the frame.
9