Segway Ninebot KickScooter Manuel De Produit page 2

EN
1
Diagram
Handlebar
Bell
Brake Lever
Headlight
Quick-release Lever
Folding Mechanism
Safety Hook
Reflector
Front Fork
Front Fender
Hub Motor
01
Dashboard & Power Button
Electronic Throttle
Dashboard & Power Button
Snap Hook
Stem
Footboard
Drum Brake
Buckle
Power Button:
Rear Fender
Speedometer:
Speed Mode:
Rear Light
& Reflector
Insurance
Plate Area
Error Notification:
Reflector
Temperature Warning:
Battery Compartment
Bluetooth:
Kickstand
Battery Level:
Charge Port
Speedometer
Bluetooth
Headlight
Temperature Warning
Press the button to turn on; press and hold the button for 3 seconds to turn off. When the KickScooter is on, press the button
to turn on/off the headlight and the rear light, and press twice to switch between the speed modes.
It displays the current speed of the scooter, as well as error codes.
There are three modes available. The top speed is as follows:
Model
D38U
Mode
ECO (Energy-saving mode)
9.3 mph (15 km/h)
D (Standard mode)
18.6 mph (30 km/h)
S (Sport mode)
18.6 mph (30 km/h)
It indicates that the scooter has detected an error.
It indicates that the battery temperature has reached 122°F (50°C) or is below 32°F (0°C).
* At this point, the vehicle cannot accelerate normally and may not be charged. Do not use until the temperature has
reverted to the normal range.
It indicates that the scooter has been successfully connected to the mobile device.
The total battery level equals 5 bars.
* The battery power is very low when the first battery bar is red. Please charge your KickScooter immediately.
Speed Mode
Error Notification
Battery Level
Power Button
02