Ingersoll Rand PROFESSIONAL TOOLS HA-EU Serie Manuel D'instructions page 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
These Sanders will operate at the free speed
specified on the nameplate if the air supply
line furnishes 90 psig (6.2 bar/620 kPa) air pressure
at the tool. Operation at higher air pressure will
result in excessive speed.
Use only a sanding pad, buffing wheel or polishing
LUBRICATION
Ingersoll–Rand No. 10
Ingersoll–Rand No. 50
Ingersoll–Rand No. 63
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International – No. C26–C4–A29
After each 2 hours of operation, if an air line lubricator is
not used, inject 1/2 to 1 cc of Ingersoll–Rand No. 10 Oil
into the air inlet.
For HXA19 and HXA27, after each eight hours of
operation, inject approximately 3 cc of Ingersoll–Rand
No. 68 Grease into the Grease Fittings.
After each eight hours of operation, inject approximately
3 cc of Ingersoll–Rand No. 67 or Ingersoll–Rand No. 77
into the Angle Head Grease Fitting.
Excessive lubrication will cause grease to work out
around the Arbor.
All manuals and user guides at all-guides.com
WARNING LABEL IDENTIFICATION
Do not carry the tool by
the hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pressure.
SANDER SPECIFIC WARNINGS
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 67
Ingersoll–Rand No. 68
Ingersoll–Rand No. 77
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
WARNING
bonnet with these tools. Do not use any grinding
wheel, bur or metal removing accessory other than
a sanding pad with these tools. Never use an
accessory having a maximum operating speed less
than the free speed of the Sander in
which it is being used.
Do not mark any nonmetallic surface on this tool with
customer identification codes. Such actions could affect
tool performance.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)