Publicité
Les langues disponibles
Les langues disponibles
PREPARATION - BEFORE INSTALLATION:
1. This product should be installed with proper installation tools.
2. Install this product while observing all warnings and precautions
stated in this instruction booklet.
3. VERY IMPORTANT: Thoroughly wash vehicle with Soap and
Water.
4. Parts storage should be flat at room temperature and in a clean
dry place. Care should be taken to avoid a dusty environment.
Left Front Door Sill
Plastic Panel
1 Alcohol
Thoroughly wash vehicle with a soft lint-free cloth. Wipe front
sill area where the Sill Plate will be installed with
alcohol wipes. Allow the area to dry completely.
Sill Plate
3
Separate Liner
Remove liner from Sill Plate. After removal of part liner, to prevent
contamination, limit touching adhesive side of Sill Plate by handling
on the edges.
DESCRIPTION
Side Sill Plate
Adhesive side of Sill Plate
Liner
ISSUE
00
Notes to the Installer
1.
Read the entire installation instructions prior to beginning the
installation of the accessory.
2.
Ensure that the vehicle is properly protected in the area that
the accessory is to be installed.
3.
To prevent vehicle damage, never place tools on top of painted
surfaces, seats, dash pad, console or floor carpet / mat.
4.
Always wear appropriate safety gear to include gloves and eye
protection when required.
Left Front Door Sill
Plastic Panel
Masking Tape
2
Dry Fit
Place masking tape along lines of plastic panel, following the edge
downward. Locate Sill Plate into place using the diagram shown
above.
NOTE: Sill Plate should remain on flat surface only, not on radius.
Left Front Door Sill
Plastic Panel
Masking Tape
4
Sill Plate Alignment
Start by aligning the edge of Sill Plate with the tape as shown.
Make sure the top edge of the Sill Plate is aligned with the plastic
panel and lay into position.
NOTE: If mislocated, lift straight up and reposition into correct location.
DATE
SUBARU OF AMERICA
9/18/23
PAGE
2/06
Publicité
