Mr. Heater Grand Teton Serie Mode D'emploi page 6

ACCESSORY INSTALLATION
BLOWER KIT (F500308) (Not Included)
The blower may be mounted to the rear of the stove.
When plugged in and while the stove is in use this
blower will propagate air along the outside of the fire
box, warming the air before it is then circulated into
the area to be heated.
WARNING: BLOWER MUST BE
DISCONNECTED FROM POWER SUPPLY
BEFORE INSTALLING. IT IS ONLY INTENDED
FOR USE WITH THIS STOVE.
Using a 5/16" open end or socket wrench, remove the
4 screws holding the rear panel. Attach the blower
mounting box to the rear of the unit using 4 of the
supplied #10 screws. Mount the blower assembly to
the mounting box with the 4 remaining #10 screws.
Figure 3 Blower Accessory Installation
ELECTRICAL CONSIDERATIONS
The Blower Motor requires 120V, 60 Hz AC and will
draw 0.26 amps of current. If you plan to ever use the
blower, the rear of the stove will need to be
power cord distance, which is roughly 65 inches (165
cm) of an electrical outlet. Lay the power cord out
such that it will not come into contact with the stove's
surface. Keep power cord at least 12 inches from stove
surfaces.
INSTALLATION
Take measurements of your space and plan for
your chimney system as detailed in the following
instructions.
Wood Fire Stove
This stove may also be installed for use in a mobile
home in the U.S. ONLY. In addition to the following
instructions, review and adhere to the mandatory
requirements on page 9.
WARNING: When this stove is not properly
installed, a house fire may result. To reduce
the risk of fire, follow the installation
instructions. Contact local building or fire
officials about restrictions and installation
inspection requirements in your area.
TOOLS REQUIRED (NOT SUPPLIED)
• Safety Glasses
• Gloves
• Pencil
• Tape Measure
• Tin Snips
• Phillips Screwdriver or
comparable electric
screw driver & drill bit.
PARTS & MATERIALS REQUIRED (NOT SUPPLIED)
• Floor Protection (see "FLOORING SPACE" and
"FLOORING MATERIAL" on page 5)
• If for use not in a mobile home: 24 MSG (minimum
standard gauge) black, or 26 MSG blue steel,
Chimney Connector single wall stove pipe having 6"
(152mm) diameter.
If for use in a mobile home: see MOBILE HOME
REQUIREMENTS
• UL 103HT (US)/ULC-S629 (CAN) listed
manufactured chimney or approved lined masonry
chimney. Must have a minimum 6" (152mm)
diameter to maximum 10" (254mm) or otherwise
maximum 85 sq. in. (550 sq. cm) area. Install per
chimney manufacturer's instructions.
• Furnace Cement (manufacturer recommends
within Rutland Code 78 or equivalent)
CAUTION: ANY DEVIATION OR ALTERATION
FROM THESE INSTALLATION INSTRUCTIONS
MAY RESULT IN DAMAGE TO YOU, THE
STOVE, YOUR CHIMNEY, AND YOUR HOME.
YOUR WARRANTY MAY BECOME VOID. READ
AND FOLLOW ALL INSTRUCTIONS. Contact
Grand Teton with any comments, concerns,
or questions.
E6
• A friend (the stove is
heavy, do not attempt
to move the stove
without assistance)
Operating Instructions and Owner's Manual