Publicité
Les langues disponibles
Les langues disponibles
English
Electrical connection
Before switching the freezer on for the first time, leave it vertical for at least two hours. Then
connect the appliance's power supply lead to a mains socket with earth contact, installed in
accordance with electrical safety regulations. The rated voltage and frequency are stated on
the nameplate on back of the freezer. The appliance must be connected to the electrical mains
and earthed in compliance with the relevant regulations and requirements. The appliance is
able to withstand short fluctuations in voltage of no more than 15% less or 10% more than the
rated voltage stated on the nameplate. If the power supply lead has to be replaced, this
operation must only be carried out by a qualified technician. The socket must be accessible
after the appliance has been placed.
Product Description
1. Temperature Control
3. 2x removable basket drawers
Before using for the first time
- Remove any exterior and interior packaging materials completely, including the adhesive
strips.
- Before it is connected to the mains, the unit must be thoroughly checked for transport
damage, including its power cord.
- Clean the unit as described in the section Maintenance and cleaning.
- To ensure proper functioning, wait for about two hours before connecting the unit and
switching it on after it has been positioned.
- When the unit is first switched on, a slight 'new' smell may be noticed. However, this will
disappear once the cooling process has begun.
Setting and selecting the freezer operating temperature
Operating for the first time
•
When operating under normal conditions and unloaded, auto mode usually stops at the
required temperature in 2 or 3 hours.
•
Then set the thermostat to the required setting for the freezer conditions.
Temperature control (Thermostat)
Caution:
do not attempt to turn it further or it will be damaged.
When the thermostat is turned clockwise to position "4",
4
2. Plastic flap
4. Door
Publicité
