Lea LE36260-60DR Mode D'emploi page 24

Move the engine switch to the "o" position. The engine will now slow down and stop
Note: If the engine does not stop after moving the switch, close the choke to make it
stop.
8.3 Angle change of rear handle
To permit vertical operation of the unit, the angle of the rear handle can be changed. To reduce
fatigue when trimming hedges, the handle can be swivelled 90° to the left or to the right.
How to change the angle (Fig.6-Fig.7)
1) Push back the throttle lever, and rotate the rear handle, pulling the rotation locking pin.
2) Rotate the rear handle 90 degrees to the right or to the left.
3) After completing the rotation, release the locking pin. To secure the rear handle, hold the
rotation locking pin gently with one finger.
4) Use only as much throttle as is needed to do the job. Excessive engine speed is
unnecessary.
5) Tilting the trimmer 5 to 10° towards the object to be cut will make things easier and
produce good results.
6) Always keep to the carburettor side of your trimmer, and never to the silencer side.
7) During the first few minutes when a new machine is first used, grease may come out of
the gearbox. Since this is excess grease, it is not a cause for alarm. Just wipe it off when
the engine is switched off.
Vertical operation
1) When rotating the rear handle to the right, hold the rear handle with your right hand, and
the front handle with your left hand.(Fig.8)
2) When rotating the rear handle to the left, hold the front handle with your right hand, and the
rear handle with your left hand. Cut using a circular movement.(Fig.9)
9. MAINTENANCE
Our machines have been designed to operate for a long period of time with a minimum of
maintenance. Continuous and satisfactory operation presupposes proper machine care and
regular cleaning.
System /
component
Fuel leaks,
fuel spillage
Fuel tank, air
filter, fuel filter
Idle adjusting
screw
Sparking
plug
Procedure Before
use
Wipe up V
Inspect/clean v
See adjusting v
idling speed
Clean and
readjust
electrode gap
Every Every
25 50
hours hours
v
v
20
Every note
100
hours
Replace if
necessary
Replace
carburetto
r if
necessary
.
GAP: 0,6-
0,7mm,
replace if
necessary