Télécharger Imprimer la page

Samsung RS21 Serie Mode D'emploi page 18

Publicité

Les langues disponibles

Les langues disponibles

CHECKING THE WATER
DISPENSER LINE (OPTIONAL)
A water dispenser is just one of the helpful features on
your new Samsung refrigerator. To help promote better
health, the Samsung water fi lter removes unwanted
particles from your water. However, it does not sterilize
or destroy microorganisms. You will need to purchase
a water purifying system to do that. In order for the
icemaker to operate properly, water pressure of 138
~862 Kpa is required. Under normal conditions, a
170 cc paper cup can be fi lled in 10 seconds. If
the refrigerator is installed in an area with low water
pressure (below 138 Kpa), you can install a booster
pump to compensate for the low pressure. Make sure
the water storage tank inside the refrigerator is properly
fi lled. To do this, press the water dispenser lever until
the water runs from the water outlet.
Water Line installation Kits are included. You
can fi nd it in one of the freezer drawers.
The new hose-sets supplied with the
appliance are to be used and that old hose-
sets should not be reused.
INSTALLING THE WATER
DISPENSER LINE
For Interior model
Parts for water line Installation
1
Water line fixer and screws
Water line fixer and screws
3
Water line
Water line
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the water line installation instructions in
the installation kit.
CAUTION
The water line must be connected to the cold
water pipe. If it is connected to the hot water
pipe, it may cause the purifier to malfunction.
DA68-03316A-00.indb 18
DA68-03316A-00.indb 18
All manuals and user guides at all-guides.com
4. After connecting the water supply to the water
Connecting the water line to the
refrigerator
1. Remove the dust cap from the water line on the
2. Remove the water pipe from the install kit and fit
3. Join the two pipes together using the
4. Join the other end of the install pipe to the main
2
Pipe connector
Pipe connector
4
Water Filter
Water Filter
CAUTION
English - 18
filter, turn your main water supply back on and
dispense about 1l to clear and prime the water
filter.
Close Main
Close Main
Water pipe
Water pipe
No gap
No gap
Close Main
Close Main
Water pipe
Water pipe
rear of the unit and fit a compression nut from the
install kit.
a compression nut to one end.
compression joint from the install kit ensuring that
the joint is water tight.
water supply and turn on the water to check for
leaks.
Remove
Remove
Loosen a
Loosen a
cap
cap
Water Line
Water Line
from unit
from unit
No gap
No gap
Water Line
Water Line
from Kit
from Kit
Only connect the water line to a drinkable
water source. If you have to repair or
disassemble the water line, cut off 6.5mm
of the plastic tubing to make sure you get a
snug, leak-free connection.
Before being used, the leakage in these
places should be examined
2015. 3. 10.
2015. 3. 10.
7:15
7:15

Publicité

loading

Ce manuel est également adapté pour:

Rs23h serieRs21hftpn