Tommee Tippee made for me Mode D'emploi page 6

Putting your pump together
Each time you use your breast pump,
check all parts of the pump for any
damage.
Wash your hands with soap and
water and dry thoroughly before
handling your breast pump.
1.
Make sure that all parts of the pump
have been washed and sterilised.
2.
Push the connector rod
2
through the bottom of
the diaphragm.
3.
With two hands gently
3
squeeze the bottom of
the diaphragm over the
ring in the base of the
connector rod. The rod
should be securely held
by the diaphragm.
4.
Place the diaphragm
4
in the top of the pump
body and push the
diaphragm edge down
around the whole
circumference of the
pump body to make
a good seal.
5.
Pick up the pump body
5
and, from the side, slide
the handle onto the body,
so that the clips on the
top slide onto the top of
the connecting rod, and
the two clips at the side
snap onto the back of the
pump body.
6.
The handle should now
6
freely move up and down
and you should see the
diaphragm lift up when
you press the handle
down.
7.
Push the horn onto
7
the body until it's fully
engaged and secure.
Turn your pump upside
down.
8.
Insert the duck-bill valve.
8
Gently squeeze the sides
of the valve to make sure
it opens.
9.
Screw in a Tommee
9
Tippee Closer to Nature
or Advanced Anti-Colic
bottle. This breast pump
is designed to fit all
Tommee Tippee Closer
to Nature and Advanced
Anti-Colic bottles and
Express & Go / Pump &
Go milk pouches with
adaptor rings (excludes
Tommee Tippee Closer
to Nature Glass bottles).
10.
Place the assembled
pump on a flat surface.
4