Roco 10525 Mode D'emploi page 5

GB ROCO Signal Switch
The switch unit operates 2 two-aspect colour light
signals not having their own signal motor.
The package contains:
1 signal switch
2 contact pins
1 adhesive tape
Application
Please refer to the circuit diagram shown at the re-
verse side. The switch can be connected only with
the 3-conductor connector 10603 (not included in
the package). The ROCO line contains an easy to
use 3- conductor flat cable 10623 as well as single
conductor cables in 9 different colours (10630 -
10638) to match these connectors. Please do not
Operation
As soon as the power supply at the side of the
switch has been connected, both return indication
LEDs will be illuminated. lf the slide switch is in the
"down" position, the signal as well as the return
indication will show "RED", the running power
to the isolated track section ahead of the signal
will be turned off. The slide switch is in the "up"
position, both signal and return indication show
"GREEN" and the running power is connected.
8010525920 IV_2022.indd 5 8010525920 IV_2022.indd 5
use any other but the cables and connectors indi-
cated since no proper operation can be guaranteed
otherwise. Power supply to the switch 10525 (14
V AC) is accomplished via the sockets at the side
and the connecting cable 10619. lf switches 10520
or 10525 are already installed, the switch is atta-
ched at the side by means of the 2 supplied contact
pins. The terminals for conneccting the colour light
signals (A) and the train control (B) are located at
the rear face of the switch.
Note: For signals having their own signal motor,
e.g. semaphore signals it is recommended to use
ROCO switch 10520 (for electromagnetic acces-
soires with end-of-stroke power disconnect) and
10521 (for electromagnetic accessoires without
end-of-stroke power disconnect)
5
24.04.2023 10:08:50 24.04.2023 10:08:50