Connecting To A Dvd Player Via Hdmi; Connecting To A Dvd Player Via Component Sockets (Ypbpr) Or Scart Cable; Remote Control Handset; Inserting Batteries - Saba LED26V1 Mode D'emploi

Connecting to a DVD Player
via HDMI
Please refer to your DVD player's instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
• If your DVD player has an
connect via HDMI for better video and audio quality.
• When you connect to DVD player as illustrated above,
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
Connecting to a DVD Player via
Component Sockets (YPbPr) or
Scart Cable
• S o m e D V D p l a y e r s
through COMPONENT SOCKETS (YPbPr).
You can connect the component video sockets with
a device that has component output. To do this, you
must use the supplied Component video connection
cable for enabling connection. First, plug single jack
of the cable to the TV's YPbPr socket (GREEN -
side). Afterwards, insert your component cable's
(not supplied) connectors into the multiple-part of
the Component video connection cable. Colours of
the connected jacks should match.
• To enable audio connection, use the
Component Audio cable. First, plug single jack
of the cable to the TV. Afterwards, insert your DVD
player's audio cable's connectors into the plural part
of the VGA/Component audio connection cable
(see illustration below). Colours of the connected
jacks should match ( RED & WHITE).
02_MB62_[GB]_1900UK_DVB T_PVR_BRONZE19_ypbpr_26916LED_10074195_50193318.indd 49 02_MB62_[GB]_1900UK_DVB T_PVR_BRONZE19_ypbpr_26916LED_10074195_50193318.indd 49
•
•
HDMI socket, you can
HDMI Cable
(not supplied)
External device
Note: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
a r e c o n n e c t e d

Inserting Batteries

•
•
VGA/
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
English - 49 -
When the connection is made, switch to
See, Input selection section.
You may also connect through the
Scart Cable
(not supplied)
External device

Remote Control Handset

Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
YPbPr source.
SCART input.
12.07.2011 13:17:23 12.07.2011 13:17:23