Connecting The Led Tv To A Pc; Using Side Av Connectors; Connecting To A Dvd Player Via Hdmi - Saba L22D980 Mode D'emploi

• Multipartiton support is available. Maximum two
different partitions are supported. If the disk have
more than two partitions, crash may occur. First
partition of the usb disk is used for PVR ready
features. It also must be formatted as primary
partition to be used for PVR ready features.
• Some stream packets may not be recorded because
of signal problems, so sometimes video may freezes
during playback.
• Record, Play, Pause, Display (for PlayListDialog)
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.
• Radio record is not supported.
• The Tv can record programmes up to ten hours.

Connecting the LED TV to a PC

For displaying your computer's screen image on your
LED TV, you can connect your computer to the TV set.
Power off both computer and display before making
any connections. Use 15-pin D-sub display cable to
connect a PC to the LED TV. When the connection
is made, switch to PC source. See Input selection
section. Set the resolution that suits your viewing
requirements. Resolution information can be found
in the appendix parts
.
Note: You should use audio inputs of side AV
connection cable (RED & WHITE) to enable sound
connection when connecting a device to your TV by
using PC input.
Note: If you connect a PC to the TV using HDMI
connection, radio interference may occur. Therefore
this type of connection is not recommended. You
should use VGA connection instead.

Using Side AV Connectors

You can connect a range of optional equipment to your
TV using the side connectors of the TV.
• When connecting a camcorder or camera , you should
use the SIDE AV socket. To do this, you must use the
supplied video/audio connection cable. First, plug
single jack of the cable to the TV's AV IN socket
(side). Afterwards, insert your camera cable's (not
supplied) connectors into the plural part of the video/
audio connection cable. Colours of the connected
jacks should match. See illustration below.
• Afterwards, you should switch to the
See the section Input selection in the following
sections for more information.
• To listen the TV sound from headphones, you
should connect headphones to your TV by using the
HEADPHONE jack as illustrated above.
Connecting to a DVD Player via
HDMI
Please refer to your DVD player's instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
• If your DVD player has an
connect via HDMI for better video and audio quality.
• When you connect to DVD player as illustrated above,
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
English - 59 -
Side AV source.
HDMI socket, you can
HDMI Cable
(not supplied)
External device