Tecnolec FT8WH Manuel D'utilisation page 66

INSTALLATION
Removing packing

1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base packing. This will require 2 or more people.
Make sure the small triangle foam (a) is
removed with the bottom packaging together.
If not, lay the unit down on the side surface and
remove it manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
WARNING :
Packaging material (e.g. Films, Styrofoam) can be dangerous for children.
There is a risk of suffocation ! Keep all packaging away from children.
Removing transit bolts

To prevent internal damage during transport, the 4 special bolts are locked.
Before operating the washing machine, remove the bolts along with the rubber bungs.
If they are not removed, it may cause heavy vibration, noise and malfunction.
1 Unscrew the bolts
with a spanner.
2 Take out the bolts along with
the rubber bungs by slightly
twisting the bung.
Keep the transit bolts for
future use.
4
3 Close the holes with
the caps supplied.