Bartec CAK-D5-A Consignes D'installation page 7

 Slide the top unit of the mounting stand over the trace heater.
 Slightly tighten the 4 fixing screws using a crosshead screwdriver.
Do not tighten them fully yet to allow the trace heater to be moved.
 Remove 5 3/4" (145 mm) of the outer jacket on the end of the trace
heater.
21-59CZ-7D0001
6
7
Notice Technical data subject to change without notice.
No claims for damage arising from alternations, errors or misprints shall be allowed.
 Push the grounding braid back. Use the screwdriver to form an
eyelet. Be careful not to damage the internal insulation jacket.
 Bend the trace heater and pull the heating element out of the
grounding braid.
 Twist the grounding braid in order to form a pigtail.
8
9
10
Page 5 / 25