HumanTechnik Signolux A-2675-0 Mode D'emploi page 22

Programming signals and assignment to the symbols
A transmitter (e.g. doorbell pushbutton) can be assigned to each symbol. This
assignment can be adapted by programming. Up to 8 transmitters can be as-
signed to each symbol.
Please keep in mind that a transmitter can only be assigned if it is not yet stored
in the memory of the signolux-Gateway. If required, you might first have to delete
the transmitter from the memory (see next paragraph).
a) Keep the function button »
light up in sequence. Let go of the function button as soon as the desired
symbol is lit. (e. g. doorbell symbol).
b) Trigger the signal of the transmitter you want to assign to the lit up symbol.
(e.g. operate the doorbell button).
c) Wait for about 20 seconds and test the function.
Deleting transmitters from memory
Wenn Sie einen Sender aus dem Speicher entfernen möchten:
a) Keep the function button »
light up in sequence. Let go of the function button as soon as the desired
symbol is lit.
b) Now press the function button »
time. All symbols will briefly light up.
Please note that this will delete all transmitters assigned to the according
symbol.
Internet-Status-LED
LED is on: Internet connection is established and active.
LED is blinking: No internet connection. Please check the network cable con-
nection or the settings of your internet router.
Transmission range
The radio signals of the Signolux transmitters within the house are designed to
have a range of 200 meters under ideal conditions.
English 22
•
« pressed for some time. The symbols begin to
•
« pressed for some time. The symbols begin to
•
« and the delete button » « at the same
°