Publicité
Les langues disponibles
Les langues disponibles
2.
Remove bumper: Using 12 mm socket, remove (4) M8 factory bolts from bumper
plate each side. Return factory bolts to vehicle owner. Gently remove bumper
beam and set aside.
3.
Install hitch (Cont'd):
c)
Using 1/2" drill bit, locate hole in bracket on bottom of frame. Drill hole through frame. Feed the carriage bolt ② and spacer ③ through the access hole using the pull wires ⑥.
Remove pull wires and loosely install conical washer ④ and hex nut ⑤ to hitch.
d)
Tighten all 7/16'' fasteners with torque wrench to 50 Ft.-Lb. (68 N*M).
© 2023 Horizon Global™ Corp. - Printed in Mexico
3.
Install hitch:
a)
Push the thin metal piece under the bumper plate inward and make it flush with
end panel each side. Align bumper beam with hitch and attach to end panel with
supplied M8 bolts ①, see Figure 1.
b)
Tighten all M8 fasteners with torque wrench to 20 Ft.-Lb. (27 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Proper torque is needed to keep the hitch secure to the vehicle when towing.
②
③
⑥
Sheet 5 of 18
Access
hole
④
⑤
25007NP
03-06-23
Rev. A
Publicité
