All manuals and user guides at all-guides.com
Check that both Isofix connectors are properly attached to the Isofix
anchor points.
Sit the child into the child car seat and fasten the safety belt, following
the indications of Fig. 25.
Make sure that the diagonal vehicle seat belt section passes through
the upper belt guide and over the child's shoulder, but does not
touch his/her neck.
Tighten the diagonal section of the safety belt by pulling in an
upward direction, until it adheres correctly and the child car seat is
safely fixed onto the car seat.
To reach the right belt position, you can easily adjust the backrest
height by following the operations in Fig.20.
Always check that the car safety belt is not twisted, and then tension
it, pulling the diagonal section in an upward direction.
Always check that the excess length of the safety belt is retracted by
accompanying the diagonal section of the belt in an upward direction.
Notes: To better protect your child:
. Make sure your child is securely fastened in the safety seat and the
harness snugly fits over his/her body.
. Never leave your child unattended in the safety seat or in the
vehicle.
. When installing your child on the rear seat of the vehicle, move the
front seat forward far enough to avoid his feet hitting the backrest of
the front seat (this may also prevent risk of injury, in the case of an
accident).
. When entering in or exiting your child from the vehicle, do it only on
the safe side of the street, away from traffic.
V. Final Check-list
1 Always check the height of the shoulder straps and make sure they
are correctly adjusted at the same
level of the shoulders or slightly above.
2 Check that both Isofix connectors are properly attached to the
9