Publicité
SURFACE MOUNTING
3. Center Z Mounting Bar at cabinet location. Make sure Z Mounting Bar is at least 1" (25mm) above fixtures.
4. Locate and drill three 7/32" (5.5mm) holes through the indent line on the mounting bar. Be sure the Z Mounting Bar is level.
Make sure Z Mounting Bar is centered.
5a. If furring strip or stud is available, use the #10 X 2" screws [SS674] provided to level and attach the Z Mounting Bar to the wall.
5b. If no furring strip or stud is available, use the provided wall anchors [203-1349], making sure to mount the Z Mounting Bar with at
least three anchors. Drill a 5/16" (8 mm) hole and insert the anchor until it is flush with the wall. Use #10 X 2" screws [SS674] and hand
tighten until there is a strong resistance. DO NOT OVER TIGHTEN.
3
4
1" (25.4 mm)
7/32"
(5.5 mm)
Drill Here
© 2020 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
5a
Minimum
1" (25.4 mm)
Minimum
[SS674]
#10 x 2" Screw
4
Z Mounting Bar
5b
5/16"
(8 mm)
SS674
Part no. CB-209-1188 06/08/20
1" x 3"
203-1349
Vitality Cabinet
Publicité
