Robern MP16 Serie Instructions D'installation

MT/MP CABINET INSTALLATION INSTRUCTIONS
KEY TO CABINET MODEL NUMBERS
HEIGHT
Options:
MT 20 D4 F B R E
MT Flat
30" [762 mm] front
MT Arch
34" [863.6 mm] front
MP Flat
39 3/8" [1000.1 mm] front
MP Arch
43 3/8" [1101.7 mm] front
WIDTH
MIRROR
Options:
SHAPE
16 (16") [406.4 mm]
or DOOR
20 (20") [508 mm]
TYPE
24 (24") [609.6 mm]
Options:
A (arch)
F (flat)
DEPTH
MD (Metallique
Options:
CD (Candre
D4 (4") [101.6 mm]
E (Cite TM
D6 (6") [152.4 mm]
O (Cite
D8 (8") [ 203.2 mm]
P (Cite TM
1
Defogger not available for these Door Types: MD, CD, E, O, P
2
These options not for these Door Types: MD, CD, E, O, P
: The MD,E, O, and P Door Types all include bevels.
NOTE
NOTE: If you are installing lights with the cabinets, see
the Installation Instructions included with light kit.
General Notes
Unpack the cabinet. Check the box thoroughly for all
hardware and loose parts as follows:
■
Cabinet
■
Shelves
■
"Z" Mounting Bar
■
Hardware Bag
Make sure that you have all the contents listed above
and in the Parts List on page 9.
WARNING: An Electrical Option cabinet contains GFCI
receptacle(s). DO NOT install this cabinet on a circuit
that powers life support equipment. DO NOT use the
GFCI receptacles in the cabinet to power life support
equipment since a trip of the GFCI would shut down the
life support equipment.
Cabfax 1090
All manuals and user guides at all-guides.com
ELECTRICAL
Options:
E (outlets,
defogger
J (outlets,
nightlight;
no defogger
MIRROR
L (outlets,
EDGE or
nightlight,
FINISH
defogger
Options:
P (plain)
B (bevel)
CR (chrome)
C (chrome)
BN (brushed nickel)
N (brushed nickel)
MG (monaco gold)
TM )
TM )
Black)
TM Oxblood)
Parchment)
This instruction sheet contains information on how to
install MP and MT cabinets. These cabinets are available
in a variety of different heights and depths. The cabinet
Model Number describes the attributes of the cabinet as
shown in the "Key to Cabinet Model Numbers" diagram.
1
)
When installing cabinets, follow these steps:
1. Read the "General Notes" section.
2
)
2. Read the "Determining Dimensions" and "Cabinet
Location" sections on page 2.
2
)
3. Read the specifi c instruction for how your cabinet(s)
will be mounted. The cabinets can be mounted in
the following ways:
HAND
■
Surface mounted (see "How to Surface Mount
Options:
R (right)
Cabinets" on page 4)
L (left)
■
Recess mounted (see "How to Recess Mount
N (left or
right)
Cabinets" on page 5)
■
Gang mounted (see "How to Gang Mount
Cabinets" on page 6)
4. If you have purchased an Electrical option with your
cabinet(s), read "Wiring an Electrical Option" on
page 7.
5. Read the "Adjustments & Maintenance" section on
page 8.
IMPORTANT: Before starting your installation, remove
the door(s) from the cabinet(s) and store them in the
cabinet box. Make sure that the edges of the door(s)
are protected. Removing the doors makes it easier to
install the cabinets.
For the doors to operate properly, the cabinets must be
installed in a square and plumb manner. Use a Square
and Level when installing cabinets.
Save these instructions for future use and reference.
An improper installation voids the warranty. Installed
cabinets cannot be returned.
If you experience any problems with your cabinet,
contact your dealer or Robern directly.
Robern • 701 N. Wilson Ave • Bristol, PA 19007
1-800-877-2376 •
Limited Warranty — One Year Term (see page 10)
1
Robern
701 N. Wilson Ave.
Bristol, PA 19007
1.800.877.2376
1-215-826-9666
FAX
209-1090 MP and MT Cabinets 03/29/07