External Connections - TLS M100 Blue Mode D'emploi

BALANCE
The BALANCE channel control is used to regulate the balance between the right and left channels for an optimal
stereo effect. Turning the control to the right reduces the volume of the left channel and vice versa. Normally, you
should leave the control in the central position.
Audio balance
The BASS and TREBLE tone controls allow for reduction or raising of the low-pitched or high-pitched tones. Set
the audio for the TLS
®
taste. When you reach the maximum value using the TAPE/CD control, this can result in distortions in playback
which can damage the speaker system.
Note: The speakers can be damaged by distorted playback. Never operate the device with distortions for
long periods. Reduce the overall volume so that the distortions cease.

External connections

MIC or (device dependent) MIC 1 and MIC 2
Wired microphones with a 6.3 mm jack can be connected to the device using the MIC or MIC 1 and MIC 2 con-
nections.
LS-OUT
The LS PLUS active TLS
the option of stereo operation. For this, please connect both devices before turning them on.
LS IN (M100 LS PLUS only)
The LS PLUS active TLS
option of stereo operation. For this, please connect both devices before turning them on.
devices according to the acoustics in the listening room or according to your personal
M100 can be connected using the LS OUT connection. The LS OUT connection offers
®
M100 can be connected using the LS IN connection. The LS IN connection of-fers the
®
Instruction manual
45